Strain Gages Sensors


Measurement of strains, deformations

and stresses

Walls, plates, pipes, tanks, connections, strains and stresses steel girders and cables


Temperature Sensors

Measurement of absolute  temperature on structure's surface  and relative temperature for  compensation of strain  measurements

Concrete cure,  structural elements and weather station

Displacement Sensors

Measurement of displacement  between two gage points
Construction joints, crack/fissure  growth and  structural members


Measurment of accelerations from  DC to low frequencies and modal analisis
Large structures, engines, turbines, generators, decks, towers and cables


Measurement of angular variation, differential sttlements  and slope displacements
Buidings, towers, footings, walls, embankments and excavations


Measurement of drainage, leakage,  water level, water pressure and pore  pressure
Pipes, tanks, excavations and embankments

​Pressure & Load Cells

Measurement of loads and  pressures

Foundation, embankment and  structural elements

For more information and details about sensors see PRODUCTS section.


Essential and critical building like power plants could cause harm to large amount of people at a time and are something to be taken care on a regular basis, if they suffer any damage due to any calamity, either natural or manmade. Expensive periodic test of critical structures can be replaced using a permanent continuous monitoring system.

With a permanent a continuous monitoring system you can:

  • Increase of plant availability
  • Increase of plant reliability
  • Improvement of the operating safety
  • Improvement of machine safety
  • Reduction of maintenance costs
  • Reduce the emerging and active faults
  • Increase in the service life of machines and systems
  • Avoidance of capital machine damages
  • Prevention of unplanned down times

The installation of sensors will allow them to measure and know the behavior of the components of the power plant such as: generators, transformers, turbines, boilers, tanks, line pipes, transmission towers and flue gasstack.

Below list of the sensors used to monitor the power plant components.

​Putting The Power Of Monitoring And Safety In Your Hands​

​Putting The Power Of Monitoring And Safety In Your Hands​